chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Bracket Replacement - Console Floor|Page 11625 > < Bracket Replacement - Console Floor|Page 11623
Page 8
background image

Removal Procedure

1. Remove the 2 screws that retain the console to the roof panel. 
2. Release the front retaining tabs. 
3. Lower the console and disconnect the electrical connectors as needed. 
4. Remove the console from the vehicle 
5. If replacing the console, remove the garage door opener if equipped. Refer to Garage Door Opener Replacement in Garage Door Opener.
6. If replacing the console, remove the OnStar (R) microphone if equipped. Refer to OnStar Microphone Replacement in Cellular Communication.
7. If replacing the console, remove the personal message player/recorder if equipped. Refer to Personal Message Player/Recorder Replacement in

Entertainment.

8. If replacing the console, remove the power sunroof switch if equipped. Refer to Sunroof Switch Replacement in Roof.
9. If replacing the console, remove the noise cancellation microphone if equipped. Refer to Microphone Replacement - Radio Volume Compensator

Interior in Roof.

Installation Procedure

1. If replacing the console, install the noise cancellation microphone if equipped. Refer to Microphone Replacement - Radio Volume Compensator

Interior in Roof.

2. If replacing the console, install the power sunroof switch if equipped. Refer to Sunroof Switch Replacement in Roof.
3. If replacing the console, install the personal message player/recorder if equipped. Refer to Personal Message Player/Recorder Replacement in

Entertainment.

4. If replacing the console, install the OnStar (R) microphone if equipped. Refer to OnStar Microphone Replacement in Cellular Communication.
5. If replacing the console, install the garage door opener if equipped. Refer to Garage Door Opener Replacement in Garage Door Opener.

6. Position the console to the roof panel. 
7. Connect the electrical connectors as needed. 
8. Seat the front retaining tabs. 

Notice:  Refer to Fastener Notice in Service Precautions.

9. Install the 2 screws retaining the console to the roof panel. 

Tighten the screws to 1.2 N.m (10 lb in).

Overhead Console Replacement - Rear

Overhead Console Replacement - Rear

Removal Procedure

Bracket Replacement - Console Floor|Page 11625 > < Bracket Replacement - Console Floor|Page 11623