TrailBlazer 2WD L6-4.2L VIN S (2003)
7.
Position the wire harness retaining clip between the headliner and the roof panel.
8.
Position the index tabs on the wire harness retaining clip to the pivot arm and install the clip until fully seated.
With the wire harness retaining clip installed, the sunshade should remain attached to the headliner.
9.
Position the inboard retainer (1) to the roof panel.
Notice:
Refer to Fastener Notice in Cautions and Notices.
10.
Install the inboard retaining screw.
Tighten
Tighten the screw to 1.2 N.m (10 lb in).
11.
With the sunshade parallel to the windshield, index the pivot arm tab to the roof panel slot.
