TrailBlazer 2WD L6-4.2L VIN S (2003)
Engine Mount: Service and Repair
Right
Engine Mount and Bracket Replacement- Right
Tools Required
-
J 41240 Fan Clutch Remover and Installer
Removal Procedure
1. Disconnect the battery negative cable.
2. Using the J41240 to secure the water pump pulley. Loosen the cooling fan hub nut from the water pump shaft.
3. Remove the MAP sensor electrical connector and retainer (1).
4. Remove the MAP sensor (2).
5. Remove the right shock module, if frame engine mount is being removed.
