TrailBlazer 2WD L6-4.2L VIN S (2003)
Important: The new actuator is in Bi-Level mode. Place the door in the middle of the travel position before you install the actuator.
1. Install the mode actuator (1).
Notice: Refer to Fastener Notice.
2. Install the screws to the mode actuator (1). Tighten the screws to 1.9 Nm (18 inch lbs.).
3. Install the left hand floor duct.
4. Install the left side sound insulator screws.
5. Recalibrate the mode actuator, See: Testing and Inspection/Programming and Relearning
Mode Actuator Console
MODE ACTUATOR REPLACEMENT - CONSOLE
REMOVAL PROCEDURE
1. Remove the console.
2. Remove the screw from the air outlet duct.
3. Remove the air outlet duct from the console.
