TrailBlazer 2WD L6-4.2L VIN S (2003)
2. Connect the side impact sensor yellow 2-way connector (5) located near the bottom right of the door.
3. Install the CPA (3) to the side impact sensor yellow 2-way connector (5) located near the bottom right of the door.
4. Install the RF door trim panel.
5. Install the SIR fuse to the fuse block (1) located in the underhood fuse block.
6. Staying well away from all air bags, turn ON the ignition, with the engine OFF.
6.1.
The AIR BAG indicator will flash 7 times.
6.2.
The AIR BAG indicator will then turn OFF.
7. Perform the Diagnostic System Check - Restraint Systems if the AIR BAG indicator does not operate as described.
Zone 7
1. Remove the key from the ignition.
2. Connect the LF side impact module yellow 2-way connector (1) located under the driver seat.
3. Install the CPA to the LF side impact module yellow 2-way connector (1) located under the driver seat.