TrailBlazer 2WD L6-4.2L VIN S (2003)
2. Install the seat switches to the switch bezel, verifying that the retaining tabs are fully seated.
3. Install the switch bezel to the seat with the 3 screws.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the front seat switch bezel screws to 3 N.m (26 lb in).
Seat Switch Replacement - Power
SEAT SWITCH REPLACEMENT - POWER
REMOVAL PROCEDURE
1. Remove the switch bezel assembly from the seat assembly.
2. Remove the buttons from the switch.
3. Release the tabs that retain the seat switch to the seat bezel assembly.
4. Disconnect the electrical connector from the switch.
5. Remove the seat switch from the seat bezel assembly.
INSTALLATION PROCEDURE
1. Connect the electrical connector to the switch.