TrailBlazer 2WD L6-4.2L VIN S (2003)
Tighten the nut in small increments, as needed, until the rotating torque is 0.40 - 0.57 Nm (3 - 5 inch lbs.) greater than the rotating torque
recorded during removal.
9. Once the specified torque is obtained, rotate the pinion several times to ensure the bearings have seated. Recheck the rotating torque and adjust if
necessary.
10. Install the propeller shaft.
11. Install the brake rotors.
12. Install the brake calipers.
13. Install the tire and wheel assemblies.
14. Inspect and add axle lubricant to the axle housing, if necessary.
