TrailBlazer 2WD L6-4.2L VIN S (2003)
Power Window Switch: Service and Repair
Quarter Window Replacement
Quarter Window Replacement
Tools Required
*
J 39032 Stationary Glass Removal Tool
*
Urethane Adhesive Kit GM P/N 12346392 or Equivalent
*
Isopropyl Alcohol or Equivalent
*
Cartridge-type Caulking Gun
*
Commercial-type Utility Knife
*
Razor Blade Scraper
*
Suction Cups
*
Plastic Paddle
Removal Procedure
Caution: If a window is cracked but still intact, crisscross the window with masking tape in order to reduce the risk of damage or
personal injury.
Important: Before cutting out a stationary window, apply a double layer of masking tape around the perimeter of the painted surfaces
and the interior trim.
1. Open the liftgate.
2. Remove the upper quarter trim.
Caution: Refer to Glass and Sheet Metal Handling Caution in Service Precautions.
Important: Keep the cutting edge of the tool against the window. Do this from inside the vehicle.
3. This will allow the urethane adhesive to be separated from the window.
*
Leave a base of urethane on the pinchweld flange.
*
The only suitable lubrication is clear water.
*
Use J 39032 or equivalent in order to remove the window.
4. If the original reveal molding on the quarter window is damaged it must be replaced.
5. With the aid of an assistant, remove the quarter window from the opening.
Installation Procedure
1. Install a stationary window into the opening.
2. Install the upper quarter trim.
