TrailBlazer 2WD L6-4.2L VIN S (2003)
Windshield Washer Hose: Service and Repair
Washer Hose Replacement - Lift Gate
WASHER HOSE REPLACEMENT - LIFT GATE
REMOVAL PROCEDURE
1. Disconnect the rear wiper hose connection (4) at the liftgate outer panel.
2. Remove the liftgate interior trim panel.
3. Remove the washer hose and grommet from the liftgate outer panel.
4. Remove the liftgate wiring harness from the liftgate.
5. Cut the rear washer hose ends where the hose ends break out of the harness.
INSTALLATION PROCEDURE
1. Route the rear washer hose along the wiring harness.
2. Tape the rear washer hose to the wiring harness with 3 wraps of electrical tape at points no more than 100 mm (4 in) apart from each other.
3. Install the liftgate wiring harness to the liftgate.
