TrailBlazer 2WD V8-5.3L (2007)
The odometer is capable of displaying values from 0-999,999 MI or KM.
If the ignition is in the OFF or UNLOCK/ACC position, the odometer can be displayed by pressing the trip reset stem. The odometer will remain
displayed for 5 seconds.
Trip Odometers
The DIC can display Trip A or Trip B odometers.
The trip odometers are capable of displaying values from 0-9999.9 MI or KM.
When the maximum value is reached, the trip odometer will roll over to 0.0.
Timer
The Timer is displayed as XX (hours) : XX (minutes) : XX (seconds).
The Timer is started and stopped using the DIC Select button.
Holding the Select button for longer than 3 seconds while the Timer parameter is displayed will reset the Timer to 00:00:00.
The Timer status and data value is retained in memory when the ignition is turned OFF. When the ignition is turned ON again, the Timer status and data
value is resumed.
The Timer maximum value is 99:59:59. When the maximum is reached, the Timer rolls over to 00:00:00 and continues to operate.
Tire Pressures
Press the trip information button until TIRE PRESSURES appears on the display. This mode shows the tire pressure in pounds per square inch (psi) or
kilopascals (kPa). Press the select button to scroll through the following information:
*
LF TIRE XX PSI
*
RF TIRE XX PSI
*
RR TIRE XX PSI
*
OR TIRE XX PSI
Fuel Information
DIC Fuel Information / Reset Capabilities
The available DIC Fuel Information and reset capabilities are as follows:
*
Range - Can not be reset
*
Avg. Fuel Economy - Can be reset
*
Inst. Fuel Economy - Can not be reset
*
Engine Oil Life - Can be reset
Range
The range display is the estimated distance that the vehicle can travel under current fuel economy and fuel level conditions.
This range is calculated from odometer information and class 2 messages.
Fuel Range is capable of displaying values from 0 - 999 MI or km.
Display appears as: RANGE: XXX MILES (English), RANGE: XXX km (Metric).
If the range is less than 40 miles, RANGE: LOW will be displayed.
Average Fuel Economy
The Average Fuel Economy (AFE) value is calculated by the cluster based on Trip Distance and Trip Fuel Used.
Pressing the Select button for longer than 3 seconds while the Average Fuel Economy is displayed in the DIC will reset both the Trip Distance and Trip
Fuel Used to 0.0.
