TrailBlazer 2WD V8-5.3L (2007)
Steering Gear: Service and Repair
Power Steering Gear Replacement
Power Steering Gear Replacement
Tools Required
J 24319-B Steering Linkage and Tie Rod Puller
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Install a drain pan under the vehicle.
3. Remove the tires and wheels. Refer to Tire and Wheel Removal and Installation.
4. Remove the outer tie rods retaining nuts and discard the nuts.
Notice: Do not attempt to disconnect a steering linkage joint by driving a wedge between the joint and the attached part. Seal damage may result
which will cause premature failure of the joint.
5. Disconnect the outer tie rods from the steering knuckles using J 24319-B.
6. Remove the steering gear crossmember. Refer to Front Steering Gear Crossmember Replacement.
7. Disconnect the lower intermediate shaft from the power steering gear. Refer to Lower Intermediate Steering Shaft Replacement.
8. Remove the power steering hose assembly to the power steering gear retaining bolt.