TrailBlazer 2WD V8-5.3L (2007)
18. Place the top half of the J 41048 on the bottom half.
19. Check to make sure there are no pinch points on the seal before proceeding with procedures.
20. Insert the bolts (2). Tighten the bolts (2) by hand until snug.
Notice: Refer to Fastener Notice.
21. Align the following items:
^
The seal
^
The halfshaft bar
^
The swage clamp
Tighten each bolt 180 degrees at a time, using a ratchet wrench. Alternate between each bolt until both sides are bottomed.
22. Loosen the bolts.
23. Separate the dies.
24. Check the swage clamp for any "lip"; deformities. If the deformities exist, place the swage clamp back into the J 41048.
Important: Ensure that the retaining ring side of the CV joint inner race faces the halfshaft bar (1) before installation.
