TrailBlazer 2WD V8-6.0L (2009)
Charging System Control Module: Service and Repair
Generator Battery Control Module Replacement
Removal Procedure
1. Remove the negative battery cable. Refer to Battery Negative Cable Replacement (4.2L Engine) (See: Battery/Battery Cable/Negative/Service
and Repair)Battery Negative Cable Replacement (5.3L and 6.0L Engines) (See: Battery/Battery Cable/Negative/Service and Repair).
2. Mark the location of the negative battery cable clips and remove the clips from the cable.
3. Remove the tape securing the generator battery current sensor to the negative battery cable.
4. Squeeze the negative battery cable branches together.
Important: Note the orientation of the generator battery current sensor prior to removal.
5. Slide the generator battery current sensor (1) off of the negative battery cable.
Installation Procedure
