TrailBlazer 4WD L6-4.2L VIN S (2002)
1. Install the trim panel to the power seat by performing the following steps:
1. Align the trim panel to the seat assembly.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the screws retaining the trim panel to the seat assembly.
Tighten the trim panel screws to 3 N.m (26 lb in).
3. Install the 3 seat switch bezel mounting screws.
Tighten the seat switch bezel mounting screws to 3 N.m (26 lb ft).
2. Install the trim panel to the manual seat by performing the following steps:
1. Install the screws in the trim panel.
2. Install the lumbar support knob.
3. Install the seat back recliner handle.
Seat Cushion Cover and Pad Replacement - Front
Seat Cushion Cover and Pad Replacement - Front
Removal Procedure
1. Remove the 3 seat switch bezel screws.
2. Remove the 4 nuts that retain the seat pan to the seat adjuster assembly.
3. Remove the clip from the front outboard seat pan stud, if equipped. Discard the clip.