TrailBlazer 4WD V8-5.3L VIN M (2006)
Trim Panel: Service and Repair
Garnish Molding Replacement - Body Side Window - Rear
GARNISH MOLDING REPLACEMENT - BODY SIDE WINDOW - REAR
REMOVAL PROCEDURE
1. Remove the bolt that retains the seat belt upper anchor to the body.
2. Remove the garnish molding from the vehicle.
INSTALLATION PROCEDURE
1. Install the garnish molding to the vehicle.
2. Install the seat belt retractor to the body.
3. Install the bolt that retains the seat belt anchor to the body.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the anchor bolt to 70 N.m (52 lb ft).