Traverse FWD V6-3.6L (2009)
4. Using spring clamps or vise grips, clamp the insert panel as shown around the loose heat stakes.
5. Apply Kent Industries Ure-Set UF Fast Curing Urethane For Plastic Repair Part # KT 13632* or the equivalent to the area around the loose stake.
Allow the adhesive to flow between the insert panel and the heat stake.
6. Cure the adhesive per the manufacturer's instructions.
7. Remove the clamps.
8. Reinstall the front side door trim panel on the affected door. Refer to Front Side Door Trim Panel Replacement in SI.
* We believe this source and their products to be reliable. There may be additional manufacturers of such products/materials. General Motors does not
endorse, indicate any preference for, or assume any responsibility for the products or material from this firm or for any such items that may be available
from other sources.
Parts Information
*This product is currently available from Kent Industries (1-888-YES-KENT).
Warranty Information
For vehicles repaired under warranty, use the table above.
Disclaimer
Technical Service Bulletin # 09-08-110-019
Date: 090722
