Traverse FWD V6-3.6L (2009)
Note: Keep the cutting edge of the knife/tool against the window. Do this from inside the vehicle.
8. If necessary, use a long utility knife or similar tool to remove the bottom corners of the window from the urethane adhesive.
9. With the aid of an assistant, remove the window (1) from the vehicle.
Installation Procedure
1. Install the liftgate window into the opening. Refer to Adhesive Installation of Endgate Stationary Windows (See: Windows and
Glass/Windows/Service and Repair/Adhesive Installation of Endgate Stationary Windows).
2. Install the rear spoiler. Refer to Rear Spoiler Replacement (Acadia, OUTLOOK) (See: Spoilers, Flaps, and Air Dams/Spoiler/Service and Repair
)Rear Spoiler Replacement (Enclave, Traverse) (See: Spoilers, Flaps, and Air Dams/Spoiler/Service and Repair).
3. Install the rear window wiper arm. Refer to Rear Window Wiper Arm Replacement (Acadia) (See: Wiper and Washer Systems/Wiper
Arm/Service and Repair/Rear Window Wiper Arm Replacement)Rear Window Wiper Arm Replacement (Enclave, Outlook ) (See: Wiper and
Washer Systems/Wiper Arm/Service and Repair/Rear Window Wiper Arm Replacement)Rear Window Wiper Arm Replacement (Traverse) (
See: Wiper and Washer Systems/Wiper Arm/Service and Repair/Rear Window Wiper Arm Replacement).
4. Connect the liftgate window defogger electrical connectors to the bus bar.
5. Install the liftgate trim. Refer to Liftgate Trim Panel Replacement (Enclave) (See: Interior Moulding / Trim/Trim Panel/Service and Repair
)Liftgate Trim Panel Replacement (Traverse) ()Liftgate Trim Panel Replacement (Acadia or OUTLOOK) ().
6. Remove the double layer of masking tape around the perimeter of the painted surfaces and the interior trim.
7. Close the liftgate.
