Traverse FWD V6-3.6L (2009)
11. Install the upper insulator.
12. Raise the front of the frame.
13. Install the front crossmember brace (1).
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
Note: If the frame insulator bolt does not screw in smoothly, run a tap through the frame nut in the body in order to remove foreign material.
Ensure the tap does not punch through the underbody.
Do not over tighten the insulator. Over tightening may collapse a spacer or strip a bolt.
14. Install the front frame to body bolts (2).
Tighten the bolts to 110 Nm (81 lb ft) plus 90 degrees.
15. Install the front crossmember brace bolts (3).
