Traverse FWD V6-3.6L (2009)
1. Inspect the underside of the seat and ensure that the adjuster bar is engaged into the seat track levers on both sides. The seat adjuster assembly has
been removed for photographic purposes only. It is not necessary to remove the seat or the adjuster assembly to perform this repair.
2. If the adjuster bar is out of position, apply inward pressure to the adjuster bar ends and reinsert the two seat track levers into the plastic end caps
on the ends of the seat adjuster bar.
Correction 3
Use the following steps to burnish the seat track bearings. This will level the bearing races.
-
Place a 90 kg (200 lb) weight on the affected seat.
-
Cycle the seat forward and rearward 30 times to smooth out the bearing race surface.
-
Occupy the seat, cycle the seat and verify the customer's concern is corrected.
*We believe this source and their products to be reliable. There may be additional manufacturers of such products/materials. General Motors does not
endorse, indicate any preference for, or assume any responsibility for the products or material from this firm or for any such items that may be available
from other sources.
Parts Information
The M-12 Flat Washers can be ordered directly from Kent Automotive.
Warranty Information
For vehicles repaired under warranty, use the table.
