Traverse FWD V6-3.6L (2009)
5. Support the right side of the frame with jackstands.
6. Remove the right side frame reinforcement bolts.
7. Loosen the right side frame bolts.
8. Lower the right side of the frame approximately 2 inches.
9. Remove the crankshaft balancer bolt.
10. Install the J 38416-2 in the nose of the crankshaft.
11. Install the J 41816 in order to remove the crankshaft balancer.
12. Tighten the center bolt of the J 41816 in order to pull the crankshaft balancer off of the crankshaft.
13. Remove the J 41816 from the crankshaft balancer.
Installation Procedure
