Traverse FWD V6-3.6L (2009)
4. Remove the catalytic converter brace bolt (2).
5. Remove the catalytic converter from the exhaust manifold.
6. Remove and discard the catalytic converter to exhaust manifold seal (1).
Installation Procedure
1. Install a NEW exhaust manifold seal (1) onto the catalytic converter.
2. Install the catalytic converter to the exhaust manifold.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
3. Install the catalytic converter brace bolt (2).
Tighten the bolt to 41 Nm (30 lb ft).
4. Install the exhaust flexible pipe. Refer to Exhaust Flexible Pipe Replacement (See: Exhaust Pipe/Service and Repair).
5. Install the catalytic converter to exhaust manifold nuts (1).
