Traverse FWD V6-3.6L (2009)
7. Install the clutch plate assembly.
Note: Ensure the drive plate does not drag against the pulley when the pulley is rotated.
8. Measure the air gap between the pulley and the drive plate. Adjust the shims to achieve a 0.35-0.65 mm (0.014-0.026 in) air gap.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
9. Install the clutch plate retaining bolt.
Tighten the bolt to 18 Nm (13 lb ft).
10. Install the drive belt. Refer to Drive Belt Replacement (See: Engine, Cooling and Exhaust/Engine/Drive Belts, Mounts, Brackets and
Accessories/Drive Belt/Service and Repair).
11. Lower the vehicle.
