Traverse FWD V6-3.6L (2009)
6. Install the auxiliary A/C evaporator tubes (2) to the HVAC module (4) and install retaining nut (1).
Tighten the nuts to 16 Nm (12 lb ft).
7. Install auxiliary evaporator tubes to retaining clips and install nuts (3) to secure.
Tighten the nuts to 4 Nm (35 lb in).
8. Install the right rear inner wheelhouse liner if necessary. Refer to Rear Wheelhouse Panel Liner Replacement (See: Body and Frame/Fender/Rear
Fender/Rear Fender Liner/Service and Repair).
9. Lower the vehicle.
10. Recharge the refrigerant to the system. Refer to Refrigerant Recovery and Recharging (See: Service and Repair/Procedures/Refrigerant Recovery
and Recharging).
11. Leak test the fittings of the component using the J 39400-A .
