Traverse FWD V6-3.6L (2009)
1. Install new O-rings to the discharge line (2). Refer to O-Ring Replacement (See: Coupler HVAC/A/C Coupler O-ring/Service and Repair/O-Ring
Replacement).
2. Install the A/C pressure switch. Refer to Air Conditioning (A/C) Refrigerant Pressure Sensor Replacement (See: Refrigerant Pressure Sensor /
Switch/Service and Repair).
3. Connect the discharge line to the condenser (3).
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
4. Install the discharge line to condenser bolt (1).
Tighten the bolt to 9 Nm (80 lb in).
5. Connect the discharge line to the A/C compressor (3).
6. Install the discharge line bolt to the A/C compressor (1).
Tighten the bolt to 9 Nm (80 lb in).