Traverse FWD V6-3.6L (2009)
4. Install the 11.96 mm (0.471 in) screen in the middle of the reduced diameter point of the fitting.
5. Place the suction hose fitting or suction hose side of the manifold into the installation tool fixture J-44551-5 (3) so it is supported by the tools legs.
Important: Correct placement of the J-44551-5 is critical.
6. Lubricate the A/C suction screen with the applicable refrigerant oil.
7. Align the screen (2), basket first; into the suction hose bore then hand tighten the bolt until contact is made between the hose, screen and tool.
8. Turn the bolt of the installation tool clockwise pressing the screen into the bore until the mandrel shoulder contacts the end of the hose fitting.
9. Unscrew the bolt and remove the installation tool from the hose or manifold.
Important: Clean the surface to be used for attaching the label.
10. Install the J-44551-1 Suction Screen Notification Label.
11. Install the A/C hose to the A/C compressor. Refer to Suction Hose Replacement (See: Suction Hose Replacement).
Suction Screen Replacement
Suction Screen Replacement
Tools Required
J 44551 Suction Screen Kit
Removal Procedure
Important: Suction screens are intended to be installed in the suction hose after a major compressor failure.