Traverse FWD V6-3.6L (2009)
7. Install the power steering gear inlet hose retaining plate bolt (1) and tighten to 12 Nm (106 lb in).
8. Install the power steering gear inlet and outlet pipe clip bolt (2) and tighten to 9 Nm (80 lb in).
9. Clean any excess fluid from the vehicle and remove the drain pans.
10. Fill and bleed the power steering system. Refer to Power Steering System Bleeding (See: Steering and Suspension/Steering/Power
Steering/Power Steering Bleeding/Service and Repair).
