Traverse FWD V6-3.6L (2009)
3. Test for less than 3 ohms between the following terminals:
*
The terminal 6 and the line hot terminal
*
The terminal 3 and the line neutral terminal
‹› If greater than the specified range, replace the accessory power outlet.
4. Test for infinite resistance between terminal 4 and terminal 1.
‹› If not the specified value, replace the accessory power outlet.
5. Connect an AC powered device to the accessory power outlet.
6. Test for less than 3 ohms between terminal 4 and terminal 1.
‹› If greater than the specified range, replace the accessory power outlet.
7. Test for 2.9-3.1 volts, with the DMM set on the diode setting and the positive test lead to terminal 6 and the negative test lead to terminal 3.
‹› If not within the specified range, replace the accessory power outlet.
8. Test for 0.0-0.1 volts, with the DMM set on the diode setting and the positive test lead to terminal 3 and the negative test lead to terminal 6.
‹› If greater than the specified range, replace the accessory power outlet.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic Trouble
Code Tests and Associated Procedures/Verification Tests and Procedures) after completing the diagnostic procedure.
*
120-Volt Accessory Power Receptacle Replacement (See: Service and Repair/120-Volt Accessory Power Receptacle Replacement)
*
Control Module References (See: Testing and Inspection/Programming and Relearning) for control module replacement, setup, and programming
Symptoms - Power Outlets
Symptoms - Power Outlets
The following steps must be completed before using the symptom tables.
1. Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle).
2. Review the system operation in order to understand the system functions. Refer to Power Outlets Description and Operation (See: Description
and Operation).
Visual/Physical Inspection
*
Inspect for aftermarket devices which can affect the operation of the power outlets. Refer to Checking Aftermarket Accessories (See: Testing and
Inspection/Component Tests and General Diagnostics).
*
Inspect the accessible system components or the visible system components for obvious damage or for obvious conditions which can cause the
symptom.
Intermittent
Electrical connections or wiring may be the cause of intermittent conditions. Refer to Testing for Intermittent Conditions and Poor Connections (See:
Testing and Inspection/Component Tests and General Diagnostics).
Symptom List
Refer to Power Outlet Receptacle Inoperative (See: Power Outlet Receptacle Inoperative) in order to diagnose the system.
