Traverse FWD V6-3.6L (2009)
1. Inspect the CMP actuator solenoid valve seal for damage. Replace the seal if necessary.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Install the CMP actuator solenoid valve (1) and bolt.
Tighten the bolt to 10 Nm (89 lb in).
3. Connect the engine wiring harness electrical connector (5) to the bank 1 exhaust CMP actuator solenoid valve.
4. Install the engine mount strut and bracket. Refer to Engine Mount Strut Replacement - Right Side (See: Engine, Cooling and
Exhaust/Engine/Drive Belts, Mounts, Brackets and Accessories/Engine Mount/Service and Repair) and Engine Mount Strut Bracket Replacement
- Right Side (See: Engine, Cooling and Exhaust/Engine/Drive Belts, Mounts, Brackets and Accessories/Engine Mount/Service and Repair).