Traverse FWD V6-3.6L (2009)
Camshaft Position Sensor: Service and Repair
Camshaft Position Sensor Replacement - Bank 1 (Right Side) Intake
Camshaft Position Sensor Replacement - Bank 1 (Right Side) Intake
Removal Procedure
1. Remove the engine mount strut and bracket. Refer to Engine Mount Strut Replacement - Right Side (See: Engine, Cooling and
Exhaust/Engine/Drive Belts, Mounts, Brackets and Accessories/Engine Mount/Service and Repair) and Engine Mount Strut Bracket Replacement
- Right Side (See: Engine, Cooling and Exhaust/Engine/Drive Belts, Mounts, Brackets and Accessories/Engine Mount/Service and Repair).
2. Disconnect the engine wiring harness electrical connector (1) from the bank 1 intake camshaft position (CMP) sensor (2).
3. Remove the CMP sensor bolt and sensor (2).
Installation Procedure