Traverse FWD V6-3.6L (2009)
4. Lift the torque back into position.
5. Install the torque tube mounting bolt.
Tighten the bolt to 185 Nm (137 lb ft).
6. Install the propeller shaft. Refer to Propeller Shaft Replacement (See: Transmission and Drivetrain/Drive/Propeller Shafts, Bearings and
Joints/Drive/Propeller Shaft/Service and Repair)
7. Remove the support and lower the vehicle.
8. Reprogram the clutch control module. Refer to Control Module References (See: Testing and Inspection/Programming and Relearning).