Traverse FWD V6-3.6L (2009)
Fuel Level Sensor: Service and Repair
Fuel Level Sensor Replacement
Removal Procedure
1. Remove the fuel tank module. Refer to Fuel Tank Module Replacement (See: Powertrain Management/Fuel Delivery and Air Induction/Fuel
Tank Unit/Service and Repair).
2. Push down on the fuel level sensor electrical connector tab (1), disengaging the retainer, and disconnect the electrical connector.
3. Remove the fuel level sensor wiring from under the module clip (2).
4. Push in the fuel level sensor tabs (1) disengaging the sensor clips from the module bucket.
