Traverse FWD V6-3.6L (2009)
Knock Sensor: Service and Repair
Knock Sensor Replacement - Bank 2
Knock Sensor Replacement - Bank 2
Removal Procedure
1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (See: Starting and
Charging/Battery/Battery Cable/Service and Repair).
2. Remove the engine oil filter. Refer to Engine Oil and Oil Filter Replacement (See: Engine, Cooling and Exhaust/Engine/Engine
Lubrication/Engine Oil/Service and Repair).
3. Lower the vehicle.
4. Disconnect the engine wiring harness electrical connector (2) from the bank 2 knock sensor (3).
5. Loosen the knock sensor bolt and remove the knock sensor.
Installation Procedure