Traverse FWD V6-3.6L (2009)
4. Connect the power steering fluid reservoir outlet hose (1) to the power steering pump.
5. Clean any excess fluid from the vehicle and remove the drain pans.
6. Install the right side catalytic convertor. Refer to Catalytic Converter Replacement - Right Side (See: Engine, Cooling and Exhaust/Exhaust
System/Catalytic Converter/Service and Repair/Catalytic Converter Replacement - Right Side).
7. Install the steering gear heat shield. Refer to Steering Gear Heat Shield Replacement (See: Steering Gear/Service and Repair).
8. Install the drive belt. Refer to Drive Belt Replacement (See: Engine, Cooling and Exhaust/Engine/Drive Belts, Mounts, Brackets and
Accessories/Drive Belt/Service and Repair).
9. Fill and bleed the power steering system. Refer to Power Steering System Bleeding (See: Power Steering Bleeding/Service and Repair).
10. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement (See: Powertrain Management/Fuel Delivery and Air
Induction/Fuel Injector/Service and Repair/Fuel Injector Sight Shield Replacement).
