Traverse FWD V6-3.6L (2009)
Installation Procedure
Note: Carefully guide the transmission tap up/tap down switch electrical harness and connector past the shift control indicator while installing the
shift control knob.
1. Install the shift control knob (1) to the shift control lever.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Install the control knob screw (1).
Tighten the screw to 4 Nm (35 lb in).
3. Lift the shift control knob trim ring (2) up to the shift control knob until a click sound is heard indicating the trim ring is secured to the shift knob.
