Traverse FWD V6-3.6L (2009)
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
6. Install the remaining bolts and washers (1) from the propeller shaft to the transfer case flange and tighten to 35 Nm (25 lb ft).
7. Tighten the center bearing mounting bolts to 25 Nm (19 lb ft).
8. Install the remaining mounting bolts (1) from the propeller shaft to the rear differential yoke and tighten to 50 Nm (37 lb ft).
9. Remove the supports from the vehicle.
10. Lower the vehicle.
