Uplander AWD V6-3.5L VIN 8 (2005)
9. Remove the lower ball joint nut.
10. Use the utility stand in order to lower the control arm and relieve the coil spring tension.
Notice: Refer to Avoid Chipping or Scratching the Coating Notice.
11. Carefully remove the coil spring and jounce bumper.
12. Remove the spring insulator (2).
13. Remove the lower control arm.
Installation Procedure
Important: Maintain proper rear park brake cable routing and clearances. Verify that the rear park brake cables have a minimum of 10 mm and a
maximum of 12 mm of clearance to the wheel drive shafts (1). Maintain this clearance using retention straps or equivalent retention (2).