Uplander FWD V6-3.5L VIN L (2006)
5. Connect the electrical harness connector (2) to the EBCM.
6. Install the air cleaner assembly.
7. If a new EBCM was installed, the EBCM must be programmed. Refer to Electronic Brake Control Module Programming and Setup. See: Testing
and Inspection/Programming and Relearning
8. Turn the ignition switch to the RUN position, do not start engine.
9. Perform the diagnostic system check. Refer to Diagnostic System Check - Vehicle. See: Powertrain Management/Computers and Control
Systems/Testing and Inspection/Diagnostic Trouble Code Tests and Associated Procedures