Uplander FWD V6-3.5L VIN L (2006)
Align the cover if equipped to the stud on the engine. Push down on the cover above the stud in order to engage the cover to the stud. Then install the
engine oil fill cap. If the vehicle is not equipped with the intake manifold cover, then proceed to step number 40.
Connect the negative battery cable at the battery.
Reprogram the PCM with the latest calibrations for the EGR system changeover. An updated PCM calibration is now available to address this concern.
This calibration, or any that follow, is designed to address this concern. Refer to Service Programming System (SPS) using the appropriate Service
Information (SI) procedures. The new PCM calibrations will be available to dealerships as part of TIS2000 incremental satellite update version 1.0,
which was broadcast to dealers on 01/08/2006. For the dealerships that use CDs, the CD version will be 1.0 for 2006, which will be mailed 01/12/2006.
As always, make sure your Tech 2 is updated with the latest software version.
