Uplander FWD V6-3.5L VIN L (2006)
5. Raise the rear crossmember.
6. Align the rear crossmember using guide pins through the rail holes (1).
7. Install the rear crossmember mounting bolts.
Notice: Refer to Fastener Notice.
8. Tighten the mounting bolts.
Tighten the rear crossmember mounting bolts to 130 N.m (96 lb ft) .
9. Install the ALC height sensor onto the crossmember and lower control arm. Refer to Automatic Level Control Sensor Replacement.
10. Install the rear differential carrier mounting bolts (5). Refer to Differential Replacement.
11. Attach the parking brake cable onto the rear crossmember. Refer to Park Brake Cable Replacement - Left Rear and Park Brake Cable Replacement
- Right Rear.
12. Connect the wheel speed sensor harness onto the rear crossmember and the lower control arm.
13. Install the rear suspension knuckle. Refer to Knuckle Replacement.
14. Install the rear tires and the wheels. Refer to Tire and Wheel Removal and Installation.
15. Lower the vehicle.
16. Inspect for rear wheel alignment and adjust as necessary. Refer to Measuring Wheel Alignment.
