Uplander FWD V6-3.5L VIN L (2006)
1. Notice:
Care should be taken to avoid chipping or scratching the spring coating when handling the rear suspension coil spring. Damage to the coating can
cause premature failure.
Important:
Position the spring so that the paint stripe (6) is facing rearward and centered to the shock absorber.
Install the jounce bumpers (1), spring seats (2), springs (4), the insulators (3, 5).
2. Index mark (6) on springs to axle.
3. Use the utility stand in order to raise the rear axle.
4. Install the rear axle tie rod to the rear axle.
5. Install the shock absorbers to the rear axle.
6. Install the brake hose bracket to the control arm.
7. Remove the utility stand.
8. Lower the vehicle.