V 20 P/U 4WD V8-379 6.2L DSL (1988)
Removing The Shaft Nut
^
Clamp J 33026 in a vise and attach the compressor to the holding fixture with thumb screws.
1. Shaft nut (1) using J 33022.
^
Hold the clutch plate and hub assembly (2) steady using J 25030.
2. Clutch plate and hub assembly (2).
^
Thread J 33013-B into the clutch plate and hub assembly (2).
Removing The Clutch Plate & Hub Assembly
^
Hold the body of J 33013-B with a wrench and tighten the center screw into the remover body.
3. Shaft key (21).
^
Retain shaft key (21) if usable.
Inspect
^
All parts and replace as necessary.
Install or Connect
Tools Required: