chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Computers and Control Systems > < Valve Clearance|Specifications
Page 1
background image

Valve Clearance: Adjustments

Valves, Adjust

    These engines do not normally require periodic adjustment. However if cylinder head or valve train requires service and/or lifter noise is excessive,
adjust valves as outlined below.

V6-229 & 262 ENGINES

1.

Start engine and allow to reach normal operating temperature, then shut engine off.

2.

With engine in position to fire No. 1 cylinder, adjust the following valves: Exhaust Nos. 1, 5 and 6; Intake Nos. 1, 2 and 3. To properly adjust
valves, tighten adjusting nut until all lash is eliminated, then tighten nut an additional 1 turn.

3.

Turn crankshaft one complete revolution, which will bring engine in position to fire cylinders. With engine in this position, adjust the following
valves: Exhaust Nos. 2, 3 and 4; Intake Nos. 4, 5 and 6.

    The following procedure, performed with the engine running should be done only in case readjustment is required.

1.

After engine has been warmed to operating temperature, remove valve cover and install a new valve cover gasket.

2.

With engine running at idle speed, back off valve rocker arm nut until rocker arm starts to clatter.

3.

Turn rocker arm nut down slowly until the clatter just stops. This is the zero lash position.

4.

Turn nut down 1/4 additional turn and pause 10 seconds until engine runs smoothly. Repeat additional 1/4 turns, pausing 10 seconds each time,
until nut has been turned down 1 turn from the zero lash position. This preload adjustment must be done slowly to allow the lifter to adjust
itself to prevent the possibility of interference between the intake valve head and top of piston, which might result in internal damage
and/or bent push rods. Noisy lifters should be replaced.

Valve Arrangement

V6-229, 231 & 262:

Right .......................................................................................................................................................................................................................E-I-I-E-I-E
Left .........................................................................................................................................................................................................................E-I-E-I-I-E

Computers and Control Systems > < Valve Clearance|Specifications