Venture V6-3.4L VIN E (1997)
The "C" pillar may have a sealer void. Refer to the shaded area in the illustration above.
Correction
Clean the area with one of the cleaners listed below and seal with a seam sealer listed below.
Condition 7
Some customers may comment on water pooling up in the corner of the weatherstrip or that the mid-floor is wet.
Cause
The weatherstrip may allow water to wick in and pool up in the corner. Refer to the arrow in the illustration above.
Correction
Drill a small 3 mm (1/8 in) hole in the interior surface of the weatherstrip. This will allow the water to drain inside the weatherstrip and exit out the
existing holes in the outside of the weatherstrip.
Condition 8
Some customers may comment on clean water in the jack compartment.
Cause
