Venture V6-3.4L VIN E (1997)
pack. If dropped or damaged during handling, the motor pack must be replaced.
5. Motor pack to hydraulic modulator TORX (R) head screws. Tighten TORX (R) head screws 4.5 Nm (40 inch lbs.).
6. Gear cover onto hydraulic modulator with TORX (R) head screws. Tighten TORX (R) head screws to 4 Nm (35 inch lbs.).
7. Hydraulic modulator.
NOTE: Bleeding is not part of the gear replacement procedure but it should be performed after installation of the hydraulic modulator. See:
Service and Repair