300 V6-3.5L (2008)
Rear Bumper Cover / Fascia: Service and Repair
Rear Fascia - Removal
REMOVAL
1. Raise and support the vehicle.
2. Remove the three push-pin retainers (1) that secure each rear wheel house splash shield (2) to the rear fascia assembly (3).
3. Remove the screw (2) that secures the rear fascia assembly (3) to the nut insert (1) in each quarter panel.
NOTE: 300 Shown. Magnum and Charger similar.
4. Partially lower the vehicle and remove the push-pin retainers (5) (three-sedan, three-wagon, one-Charger) that secure the rear fascia assembly (6)