300 V6-3.5L (2008)
1. The push pin fastener is in the open position (1) when the center pin is pull outward approximately 2 mm. Then the push pin fastener is ready to be
used.
2. To install push pin place it into position, and push the center pin in flush with the head of the push pin to lock it into position (2).
3. To remove the push pin fastener, push the center pin inward approximately 2 mm to release push pin fastener (3).
Front Floor Foot Rest - Removal
REMOVAL
1. Remove the trim from the driver side lower cowl side inner panel. See: Cowl Trim/Cowl Trim - Removal.
2. Remove the three push-pin fasteners that secure the driver side front carpet to the cowl side inner panel and the front door opening sill.
3. Pull the front floor carpet up and away from the foot rest (1) far enough to access and remove the nut (2) that secures the foot rest to the weld stud
(5) on the front floor panel.
4. Lift the base of the foot rest upward far enough to disengage the tab (3) at the top of the foot rest from the slot (4) in the dash panel.
5. Remove the foot rest from the vehicle.
Front Floor Foot Rest - Installation
INSTALLATION