300 V6-3.5L (2008)
7. Install tire and wheel assembly (1). Tighten wheel mounting nuts (3) to 150 Nm (110 ft. lbs.) (Police - 190 Nm (140 ft. lbs.)). See:
Maintenance/Wheels and Tires/Service and Repair/Removal and Replacement/Tires and Wheels - Installation
8. Lower vehicle.
9. Pump brake pedal several times to set pads to caliper and brake rotor.
10. Check and adjust brake fluid level in reservoir (1). See: Hydraulic System/Brake Fluid/Service and Repair
CAUTION: When NEW brake pads have been installed, keep in mind that braking effectiveness might be somewhat reduced during the
first brake applications following installation.
CAUTION: A burnish procedure must be performed anytime NEW brake pads or rotors are installed on a vehicle equipped with the Police
Package. This procedure is particularly important in situations where high speed pursuit is a possibility. It is recommended that the procedure
be performed by the Police agency operating the vehicle so it can be performed in a safe controlled environment. This information is covered in
the Police Package Owners Manual Supplement which was supplied when the vehicle was originally delivered.
11. Road test vehicle making several stops to wear off any foreign material on brakes and to seat brake shoes. If the vehicle is equipped with the
Police Package, a burnish procedure must be followed (Refer to preceding Caution).
Front/Rear - SRT8
INSTALLATION
NOTE: Perform STEP 1 through STEP 10 on each side of vehicle to complete pad set installation before proceeding with STEP 11.
1. Make sure all caliper pistons are fully seated (bottomed) in bores.