300 V6-3.5L (2008)
Hydraulic System Junction Block: Service and Repair
Installation
INSTALLATION
1. Install junction block (5), pushing mounting bracket down into mounting grommets (8) located in body of vehicle.
2. Install brake tubes to rear (1 and 3) at hydraulic control unit. Tighten tube nuts to 20 Nm (177 in. lbs.) torque.
3. Install brake tubes (1, 2, 3 and 10) at junction block (5). Tighten tube nuts to 20 Nm (177 in. lbs.) torque.
4. Remove brake pedal holding tool.