300 V6-3.5L (2008)
Rocker Arm Assembly: Procedures
INSPECTION
The rocker arm shafts are hollow and are used as lubrication oil ducts. The rocker arm and shaft assembly on the right side of the engine has an oil
passage hole from the cylinder head located at the third rocker shaft support pedestal. The rocker arm and shaft assembly on the left side of the engine
has an oil passage hole from the cylinder head located at the second rocker shaft support pedestal.
NOTE: To prevent air ingestion into lash adjusters, avoid turning rocker arm assembly upside down.
CAUTION: Do not allow rocker arm assembly to rest on lash adjusters, as damage may occur to lash adjuster and plastic retainer.
The intake and exhaust rocker arms are different. They should be identified before disassembling the assembly.
Check rocker arms for wear or damage :
-
Roller scuffing or wear
-
Shaft bore scuffing or wear
-
Swivel pad on lash adjuster missing or broken
