300 V6-3.5L (2008)
Valve Cover: Service and Repair
Spark Plug Tube
Removal
REMOVAL
1. Remove cylinder head cover(s). See: Cylinder Head Cover - Removal
2. Using suitable locking pliers, remove the tube from the cylinder head and discard tube.
3. Clean area around spark plug with Mopar(R) Parts Cleaner or equivalent.
Installation
INSTALLATION
1. Apply Mopar(R) Stud and Bearing Mount to a new tube (1) approximately 1 mm (0.039 in.) from the end of tube, in a 3 mm (0.118 in.) wide area.
2. Install sealer end of tube (1) into the cylinder head. Then carefully install the tube (1) using a hardwood block and mallet. Install the tube (1) until
it is seated into the bottom of the bore.
3. For spark plug tube (1) seal replacement, See: Cylinder Head Cover - Removal.
4. Install cylinder head cover(s). See: Cylinder Head Cover - Installation